功能描述：
設計模式：自動工藝參數，如溫度，進片速度，補充溶液大小，均可實現按需調節，真正無憂化操作。它共有九組程序，可供您按照不同的沖洗要求進行調節。
預處理模式：一旦編程，溫度設定將得到準確的控制，保持各槽溫度為設定溫度，溫度公差±0.2℃。他是有CPU控制加熱溫度，并使循環泵不斷地工作溶液均勻，達到為沖洗膠片提供的待機狀態。一旦溫度升高造成誤差，便能及時啟動水循環制冷
INDX 900 NDT
X-Ray-Filmprocessor
Technical Specifications
Processing applications: All type of Industrial X-Ray films
Film thickness: min. 0,10 mm
Materialwidth: min. 6 cm (2.36") - max. 36 cm (14")
Material length: min. 10 cm (4")
Time in Developer: min.30 sec max. 150 sec
Intake Speed: 38 cm/min 8 cm/min
Cycle Time: 2,7 min (162 sec) 13,6 min (816 sec)
(see the table on one of the next page)
INDX 900
Tank capacity - Developer: 2,6 L
Fixer: 2,5 L
Wash water: 3 L
Solution heating(Fix and DEV): variable in a range of 18°C - 43°C
(350W Inline Heater)
Dryer: warm air
Replenishment: fully automatic.
replenishment is microprocessor controlled and
calculated from information received from sensors
measuring the width and length of material entering the
processor. Replenishment cycles are variable.
power supply: 1 / N / PE~ 230V (+6% / -10%), 50Hz, 13A, 1.7KW
(alternatives are avaliable on request)
water supply: 2-way magnetic valve, with 3/4" hose connection by using a
DVGW-approved system-separating device or pipe-separating
device.
Wash water flow rate: 1,5 ltr/min when film is in process
Wash water supply pressure: 3 - 10 bar
Wash water supply: filtered at a temperature of 10°C - 15°C
INDX 900
Weight: Empty 58 kg
With solution 66 kg
