一、概述：是我公司新產品，配置彩色液晶觸摸屏， 的人工智能模糊化控制，采用進口紅外探測原理傳感器，溫濕度和 濃度數據更加穩定準確、使用壽命長，砌墻磚碳化試驗箱用于進行混凝土空心砌塊、砌墻磚碳化試驗的設備。數據自動記錄存儲，可導出，斷電記憶。進口壓縮機 節能。
I. Overview of TH-W wall brick carbonization test box: It is our new product, equipped with color LCD touch screen, artificial fuzzy control, imported infrared detection principle sensor, temperature and humidity and carbon dioxide concentration data are more Stable and accurate, long service life, the wall brick carbonization test box is used to carry out the concrete hollow block and wall brick carbonization test equipment. The data is automatically recorded and stored, which can be exported and stored in power failure. Imported compressors are energy efficient
二、符合標準：
產品符合混凝土小型空心砌塊檢驗方法 GB/T 4111-1997和GB/T2542-92 《砌墻磚試驗方法》與DL/T5150-2001《水工混凝土試驗規程》中碳化試驗設備的要求。
Second, the TH-W wall brick carbonization test box meets the standards:
The product meets the requirements of the carbonation test equipment in the test methods for small concrete hollow blocks GB / T 4111-1997 and GB / T2542-92 "Test methods for masonry bricks" and DL / T5150-2001 "Testing rules for hydraulic concrete".
三、技術參數：
★控制溫度:15-30℃ 精度：0.5℃
★均勻性:≤1℃ 控制濕度：50-90% 精度：3% 均勻性：≤2%
★內凈尺寸: 900×600×650毫米
★外形尺寸: 1650×850×1100毫米
Third, the technical parameters of TH-W wall brick carbonization test box
★ Control temperature: 15-30 ℃ Accuracy: 0.5 ℃
★ Uniformity: ≤1 ℃ Control humidity: 50-90% Accuracy: 3% Uniformity: ≤2%
Inner net size: 900 × 600 × 650 mm
★ Dimensions: 1650 × 850 × 1100 mm
四、操作規程：
★ 先將CO2鋼瓶與箱體用高壓氧氣管連接；
★打開箱體的側蓋，把加濕器的水箱取下，把水注滿調節噴霧量大小（順時針為大、，逆時針為小）；
★ 將經過處理的試件放入碳化箱內的鐵架上，各試件經受碳化的表面的間距至少不小于50mm；
Four, TH-W wall brick carbonization test box operation rules:
★ First connect the CO2 steel cylinder to the box with a high-pressure oxygen pipe;
★ Open the side cover of the box, remove the water tank of the humidifier, and fill the water to adjust the spray volume (large clockwise, small counterclockwise);
★ Put the treated test pieces on the iron frame in the carbonization box, and the distance between the surface of each test piece subjected to carbonization is not less than 50mm;
