一、隔墻板抗沖擊試驗儀產品簡介：
隔墻板抗沖擊試驗儀依據JG/T169-2005《建筑隔墻用輕質條板》設計制造。
First, product introduction
The wall panel impact tester is designed and manufactured according to JG/T169-2005 "Lightweight strip for building partitions".
二、隔墻板抗沖擊試驗儀技術參數:
1、標準砂袋質量30kg
2、沖擊高度500mm
3、外形尺寸：1900×1500×2600mm
4、重量：420kg
Second, technical parameters
1. Standard sａnd bag quality 30kg
2, the impact height of 500mm
3. Dimensions: 1900×1500×2600mm
4, weight: 420kg
三、隔墻板抗沖擊試驗儀使用方法:
1、取條板三塊為一組樣本，組裝并固定，上下鋼管 距離為板長減去100mm，即（L-100）mm。板縫用與板材材質相符的專用砂漿粘結，板與板之間擠緊，接縫處用玻璃纖維布搭接，并用砂漿壓實、刮平。
2、24h后將裝有30kg重，粒徑2mm以下細砂的標準砂袋用直徑10mm左右的繩子固定在其 距板面100mm的鋼環上，使砂袋垂懸狀態時的 位于L/2高度處。
3、以繩長為半徑延沿圓弧將砂袋在板面垂直的平面內拉開，使重心提高500mm（標尺測量），然后自由擺動下落，沖擊設定位置，反復5次。
4、試驗結束僅適用于所測條板長度尺寸以內的條板。
Third, the method of use
1. Take three strips as a set of samples, assemble and fix them. The center distance between the upper and lower steel tubes is 100mm, which is (L-100)mm. The joints are bonded with a special mortar that conforms to the material of the board. The board is tightly squeezed between the boards. The joints are covered with fiberglass cloth and compacted and smoothed with mortar.
2. After 24h, a standard sａnd bag with a weight of 30kg and a fine sａnd of 2mm or less is fixed with a rope with a diameter of about 10mm on a steel ring with a center of 100mm from the plate surface, so that the center of gravity of the sａnd bag is in the hanging state. /2 height.
3. Extend the sａnd bag along the arc with the length of the rope as the radius. Increase the center of gravity by 500mm (measured by the ruler), then swing freely and impact the set position for 5 times.
4. The end of the test is only applicable to the strips within the length of the measured strip.
