Lattice USB下載線 HW-USBN-2B全新進口原裝
1.For devices that have a VCCJ pin, the VCCJ must be connected to the cable’s VCC, and a 0.1µF decoupling capacitor is required on VCCJ close to the device. Please ref
Lattice USB下載線 HW-USBN-2B全新進口原裝
Lattice USB下載線 HW-USBN-2B全新進口原裝
Lattice USB下載線 HW-USBN-2B全新進口原裝
- For devices that have a VCCJ pin, the VCCJ must be connected to the cable’s VCC, and a 0.1µF decoupling capacitor is required on VCCJ close to the device. Please refer to the device data sheet to determine if the device has a VCCJ pin.
- For older Lattice ISP devices, a 0.01µF decoupling capacitor is required on ispEN/ENABLE of the target board.
- The TRST and DONE pin is multiplexed on the ispDOWNLOAD USB cable. If the device TRST signal is available on the board, connect the USB flywire TRST/DONE wire to TRST. If the device DONE signal is available on the board (or if both TRST and DONE are available), con-nect the USB flywire TRST/DONE wire to DONE. Please make sure the correct setting is selected in ispVM/Diamond Programmer (Options, Cable and I/O Port Setup). This will l ispVM/Diamond Programmer whether the TRST/DONE cable is used as a TRST or a DONE signal.
- A 4.7K pull-down resister is recommended on TCK of the target board.
Table lists the recommend pin connections. Please contact Lattice technical support for information on unlisted device families. (: techsupport@latticesemi.com, phone: 1-800-LATTICE).
***************************************************
聯 系 人 ;雷 俊 （先 生）
深圳博瑞圖電子科技有限公司
0755-36675904
MOB:13823138950
0755-83244576
ADD:深圳市福田區中航路世紀匯都會軒1416室
: 401512450
網 址：www.szprotools。。ｃｏｍ
***************************************************
承接銷售元器件IC一條龍、專注10年
